I'm starting a collection!!!

junglestylz

junglestylz

1000 Post Club
#1
Messages
1,024
Likes
0
Location
Las Vegas, NV
#1
I went to talk to the owner of the little red 1991 BMW 318is and talked him down to $2500. It is missing a door latch (outside), windshield wipers, a small piece of trim, and 1 fog light is broken. All the trim and other parts I can snag off my 1985 318i. It only has 97,000 kiles on it. heheheheheheheheheh. I NEED MORE!
 
junglestylz

junglestylz

1000 Post Club
#3
Messages
1,024
Likes
0
Location
Las Vegas, NV
#3
I am going to take the parts off the 1985 and put them on the 1991. I am also going to swap out the springs, swaybars, control arms, offset conrtol arm bushing, camber plate, shocks, seat, and dash into the 1991. It is a very decent little car. No scratches, dents, or dings in the body work. New paint (the owner owns a body shop) and the profile gasket has already been replaced. I will post pics when I get it all done.
 
R

rjp325i

Active Member
#9
Messages
511
Likes
0
Location
Henderson, NV
#9
No I have not. Do I need to install them on the hard drive or can I work from CD? Are there instructions on the CDs for use? I'll probably look at them today. I'm now trying to locate a small leak in the radiator if in fact there is one. Dan's shop indicated I have a small one and to watch it but I don't have to rush to repair. If I have to replace I saw Pelican parts has radiator for'89 325iA listed at $214, BMP Design at $210 while BAS has it for $246. I'll have to check out Eurasian too. I want a quality radiator. I'm not in a hurry right now as I will be going on vacation the Sat after Thanksgiving.
 
junglestylz

junglestylz

1000 Post Club
#10
Messages
1,024
Likes
0
Location
Las Vegas, NV
#10
There should have been a sheet of paper with the instuctions with the CD's, but I might have forgotten to give it to Chris. At any rate, I can post the instructions on here tomorrow from work.
 
You must log in or register to reply here.


Top