Who knows how to bleed the slave Cyl.¿¿

junglestylz

1000 Post Club
Messages
1,024
Likes
0
Location
Las Vegas, NV
#1
I am in the process of installing the slave cylinder right now and was wondering if anyone could give me a step by step process for bleeding it, or if there are any little tricks to installing one¿

Nevermind, It is done!!!!!!!!!YAYAYAYAYAYAYAYAYAYAYA
 
Last edited:
Messages
1,303
Likes
0
Location
Charleston, SC
#2
Just in case someone comes looking for how to:

Get down by the slave, have a buddy pump the clutch a few times and hold the clutch. Open the bleeder until the air is not apparent in the oil. Repeat as necessary.
If needed, remove the slave from the tranny and squeeze the air out slowly by hand with the push rod.
(also found in bently manual)
 


Top